Question regarding pushers on UG Compur

Posts

1,369

Likes

1,755

Rasputin

·Feb 8, 2018

I recently had my Compur serviced but my watchmaker is having difficulty securing one of the pushers in the case. Apparently it keeps falling off. There was no issue with the pushers prior to servicing. Any trick with these that my watchmaker may not know about?

 

Posts

464

Likes

1,165

10H10

·Feb 9, 2018

The holding screw is too short or not tight enough ?

 

Posts

976

Likes

3,090

Florent

·Feb 9, 2018

10H10

The holding screw is too short or not tight enough ?

+1 probably the explanation !

 

Posts

1,369

Likes

1,755

Rasputin

·Feb 9, 2018

10H10

The holding screw is too short or not tight enough ?

Any other likely causes? I’d like to hand him a troubleshooting checklist 😉

 

Posts

976

Likes

3,090

Florent

·Feb 9, 2018

I don't think so. Maybe the pusher itself is not correctly fixed to the pusher stem ?

 

Posts

47

Likes

161

vintagechrono

·Feb 11, 2018

Small differences in protrusion betwen the two buttons are normal.IMHO.Mine..

 

Posts

976

Likes

3,090

Florent

·Feb 11, 2018

I think your two pushers are different. The top one is ok, the lower not is different and too small 👎 but that’s only my point of view...

 

Posts

47

Likes

161

vintagechrono

·Feb 14, 2018

Florent

I think your two pushers are different. The top one is ok, the lower not is different and too small 👎 but that’s only my point of view...

They are absolutely identical:5,2 mm.😀