Omega 168.005 pie pan crystal

Posts
29
Likes
4
I keep having the same problem usingGS ET 30.6 crystals with original omega split cut ring that when crystal is pressed in tight the watch stops! Happened with 5 diff pie pan dials, diff cases, diff crystals. If I don’t press crystal in completely it runs. I thought perhaps second pinion too long but for 5 diff movements, 561/564? I tried hi dome crystal without tension ring and they run but dial needs a tension ring. Did omega use a specific height 30.6 crystal for these pie pan dials in this 168.005 case? If so what was the height or numbet
 
Posts
12,950
Likes
22,414
It always best to try searching as similar questions have often been asked before



 
Posts
29
Likes
4
It always best to try searching as similar questions have often been asked before



Thx. So there are two heights! Funny how two diff comments have two diff number for the 5.4m height crystal.

Next where to find them as non on eBay. And high dome don’t take tension rings and these dials need them.