- Posts
- 3
- Likes
- 0
AlwaysLearning
路Well... I am a true newbie.. a budding glutton for all thing that move! So please do show grace if I come off a bit elementary! 馃槈
Constellation 1330 Quartz (Date):
Hour hand is not keeping up - Advances about every 4 hours - Mins and Secs run perfectly.
I can set the watch with no problems (functions as it should when setting)
I just purchased the watch and the stem was not tight in the crown... It appear to also be a little short.... I applied epoxy to the threads and bottomed it into the crown, then backed it out 1 turn (in case it was to short)... Still no joy.
The keyless works is holding perfectly also.
Looking for some ideas?
I am also looking for a 1340-9400 motor for another project!
Thanks for any guidance!
UPDATE:
Well interestingly I decided to pull the crown (as if to set the hours) and leave it out - no the hours are advancing properly... I am very confused now???
Constellation 1330 Quartz (Date):
Hour hand is not keeping up - Advances about every 4 hours - Mins and Secs run perfectly.
I can set the watch with no problems (functions as it should when setting)
I just purchased the watch and the stem was not tight in the crown... It appear to also be a little short.... I applied epoxy to the threads and bottomed it into the crown, then backed it out 1 turn (in case it was to short)... Still no joy.
The keyless works is holding perfectly also.
Looking for some ideas?
I am also looking for a 1340-9400 motor for another project!
Thanks for any guidance!
UPDATE:
Well interestingly I decided to pull the crown (as if to set the hours) and leave it out - no the hours are advancing properly... I am very confused now???
Edited:
