Omega Speedmaster Runs without winding

Posts
18
Likes
65
Bc7aIfzRRnTMEBWB4dHHdlCcpYyhnoViH3gUX0wJ.jpg

Hi

I picked up my speedmaster 2022 model (was completely stopped, needed winding) and was playing around with it and the seconds hands started moving like it was an automatic. Is this normal, I’m a bit of a newbie to manual winds but not to automatics.


It’s done 2 hours 20 mins without any winding. But I'm sure it was very slow, due to be dying of energy.


it’s freaking me out a little and there’s no way it’s a fake. Bought from an Omega Boutique.
 
Posts
144
Likes
203
Merry Christmas everyone, my 3592 does the same if I last recall. Same goes for my pam111 which is a manual wind movement as well.
 
Posts
15,615
Likes
46,551
Rumours are about that Rolex with their Perpetual, and Omega have partnered to produce a Speedmaster Perpetual that never needs winding! You must have one of these hybrids. 😁
 
Posts
144
Likes
203
I didn’t time how long though, if yours is doing this for 2 plus hours then that’s another story.
 
Posts
7,720
Likes
14,273
It's a Christmas miracle! 😁
It's also normal. 😀 There is often a little residual energy in a rundown watch so when picked up it may run for a short time (a couple of minutes).
 
Posts
18
Likes
65
It's also normal. 😀 There is often a little residual energy in a rundown watch so when picked up it may run for a short time (a couple of minutes).
that's fine, but a couple of hours is bizarre
 
Posts
6,141
Likes
29,847
Did you leave the chronograph running before you put it down and did you stop it when you picked it back up?
 
Posts
18
Likes
65
Did you leave the chronograph running before you put it down and did you stop it when you picked it back up?
Chrono was off.

When I picked it up I did try the chronograph, it didn't even manage 1 sec, which is correct as it had no energy.
 
Posts
6,141
Likes
29,847
Chrono was off.

When I picked it up I did try the chronograph, it didn't even manage 1 sec, which is correct as it had no energy.
I'm confused as your pic shows the chronograph ran for 3 hours and 46 minutes, the chrono hand seems to have stopped at 59 seconds.
 
Posts
18
Likes
65
I'm confused as your pic shows the chronograph ran for 3 hours and 46 minutes, the chrono hand seems to have stopped at 59 seconds.
Apologies, I just put a pic up to show the model, that an older pic, My bad
 
Posts
4,593
Likes
10,810
It's also normal. 😀 There is often a little residual energy in a rundown watch so when picked up it may run for a short time (a couple of minutes).

No, it's a miracle.
 
Posts
4,593
Likes
10,810
Just like those tedious posts on WUS about the guy who gets his grand dad's long lost Rolex out of the safety deposit box in the bank after it sat there for decades. "I picked it up and it was still running!"
 
Posts
18,243
Likes
27,560
It can happen. Also leads me to believe it needs a service as stickion was high in some part of the movement.
 
Posts
24,577
Likes
54,570
yep thanks, I understand that as it seems the chronograph uses a lot more energy

It's a subtlety, but my understanding is that the movement experiences more friction/resistance when the chronograph is running, so the movement stalls with more energy still remaining in the mainspring because not enough torque is exerted.
 
Posts
24,577
Likes
54,570
that's fine, but a couple of hours is bizarre

If it runs for 8 days, let us know. (Some members will get it!)
 
Posts
4,593
Likes
10,810
It's a subtlety, but my understanding is that the movement experiences more friction/resistance when the chronograph is running, so the movement stalls with more energy still remaining in the mainspring because not enough torque is exerted.

For sure. Even happens with date change.