- Posts
- 7,198
- Likes
- 23,349
M'Bob
·Why do they have two threaded holes by the tip, but only one is filled with a screw?
Was wondering about watchmaker screwdrivers…
- Posts
- 13,483
- Likes
- 31,783
X350 XJR
··Vintage Omega AficionadoThe blade ends have a flat edge on one side to keep them from turning.
Probably cheaper/easier to manufacture with a straight through hole.
Probably cheaper/easier to manufacture with a straight through hole.
- Posts
- 7,198
- Likes
- 23,349
M'Bob
·The blade ends have a flat edge on one side to keep them from turning.
Probably cheaper/easier to manufacture with a straight through hole.
On mine, both holes are threaded, so I’m still puzzled as to why the make would bother threading both if they didn’t need to. I can only it’s a spare in case one side gets buggered up.
- Posts
- 18,067
- Likes
- 37,712
JimInOz
··Melbourne AustraliaIt's simply a manufacturing expediency/efficiency.
To only have one side drilled and tapped would require precise drill depthing and two threading taps (one start/one bottoming).
A straight through hole only requires a single pass with a drill and a single tap to do the threading.
To only have one side drilled and tapped would require precise drill depthing and two threading taps (one start/one bottoming).
A straight through hole only requires a single pass with a drill and a single tap to do the threading.
- Posts
- 7,198
- Likes
- 23,349
M'Bob
·It's simply a manufacturing expediency/efficiency.
To only have one side drilled and tapped would require precise drill depthing and two threading taps (one start/one bottoming).
A straight through hole only requires a single pass with a drill and a single tap to do the threading.
Thanks Jim, appreciated.
I don’t have a tremendous array of screwdrivers, but I notice when I pull a blade out for replacement, on the bottom, there’s a rounded end, and on the other side, a flat spot, where I’m assuming the screw is supposed to abut up against.
But on my screwdrivers, when you stick any blade in, they spin freely, meaning the flat spot does not automatically line up right under where the screw is supposed to go. So you have to do it by feel. Is that how most of them are constructed, even the better quality models?
- Posts
- 434
- Likes
- 841
noless
·Thanks Jim, appreciated.
I don’t have a tremendous array of screwdrivers, but I notice when I pull a blade out for replacement, on the bottom, there’s a rounded end, and on the other side, a flat spot, where I’m assuming the screw is supposed to abut up against.
But on my screwdrivers, when you stick any blade in, they spin freely, meaning the flat spot does not automatically line up right under where the screw is supposed to go. So you have to do it by feel. Is that how most of them are constructed, even the better quality models?
- Posts
- 29,815
- Likes
- 77,159
Similar threads
- Posts
- 5
- Views
- 188
- Posts
- 0
- Views
- 102
- Posts
- 18
- Views
- 2K
