Correct length Speedmaster Chrono hand

Posts
247
Likes
291
Hi all,

Apologies if this has been asked before, but I am really struggling to find a definitive answer. Does Omega make a service chrono hand of the correct length that would fit a 105.012-66 CB? Mine currently has (luminova?) replacements. I believe the hour and minute hand are correct dimensionally, but the chrono hand looks slightly too short.

Thanks!

 
Posts
30,332
Likes
78,272
The correct hand is part number 066PP01001. The length is 14.25 mm - this is measured from the center of the mounting tube to the tip of the hand, not the overall length. Note that this hand is .5 mm shorter than on say a more modern 35705000, which is 14.75 mm.
 
Posts
247
Likes
291
The correct hand is part number 066PP01001. The length is 14.25 mm - this is measured from the center of the mounting tube to the tip of the hand, not the overall length. Note that this hand is .5 mm shorter than on say a more modern 35705000, which is 14.75 mm.
Thank you Archer. So that hand would reach out to the edge of the indicies on the dial? Mine is probably 5mm short of the edge at the moment. It appears essentially the same length as the minute hand.

I believe it was serviced by Omega in the late 90s so I would assume that was when the hand swap happened.
 
Posts
30,332
Likes
78,272
Thank you Archer. So that hand would reach out to the edge of the indicies on the dial? Mine is probably 5mm short of the edge at the moment. It appears essentially the same length as the minute hand.

I believe it was serviced by Omega in the late 90s so I would assume that was when the hand swap happened.
That's not 5 mm too short.

The minute hand is 14 mm, and the chronograph seconds hand is 14.25 mm. I don't think there's anything wrong with that hand...
 
Posts
247
Likes
291
That's not 5 mm too short.

The minute hand is 14 mm, and the chronograph seconds hand is 14.25 mm. I don't think there's anything wrong with that hand...
Yes sorry I had your reply stuck in my head! I am sure I read somewhere that the pointer part of the chrono hand is slightly shorter on service replacements.

It is a very small detail, but I was just thinking of getting a second set of hands to try reluming to match the dial better so wanted to check about the length first.

Tritium Hand



My replacement hand





To me the proportions are definitely different and the service replacements is less pointy.
Edited: