Speemaster mark II pusher gasket dimensions

Does anyone know the size of the gaskets or o-rings that goes inside the Speedmaster mark II pushers? I measured the inside of the "housing" and the pusher themselves and got hold of 2.50x0.35x1.80 mm o-rings, but it seems I have to stack 3 on top of each other to fill the height in there. So maybe they are not round or possibly thicker than the ones I got? I think the pushers are the same as on the Moonwatch, but a bit shorter so the gasket should be the same.
Thanks!

Thanks! I haven't found a part number for seals themselves so I assume the whole pusher is just replaced. But as with most crowns, it should be possible to just replace the rubber part. Especially for original pushers.

I'm not sure the seals are to be replaced without the pushers as I'm led to believe that they're integral to them.
Hopefully someone more knowledgeable on the matter than me, will be along soon

Great, thanks a lot! If you can get new pushers it's probably best to replace them. But if they are in good shape, new seals will be just as good. And they are expensive and/or hard to get without an account.