SKX007 bezel not turning.

ZIELSZIEK · Feb 6, 2020

Hello Omega Forums, I would greatly appreciate if someone could help me out on this one. I have an SKX in which I installed a dagaz flat sapphire. After attempting to put the bezel back on, it just became stuck. No movement whatsoever.
The crystal is properly seated, the watch gains no water under the tap, the bezel click spring and bezel gasket have been lubricated.
Thank you.

duc · Feb 6, 2020

I had this happen to me once. The o-ring had moved out of where it was supposed to seat and jammed the bezel. The only thing that worked for me was to remove it, replace the o-ring and reinstall the bezel. I used a little bit of silicone grease on the o-ring to keep it from moving the second go-round.

ZIELSZIEK · Feb 6, 2020

duc
I had this happen to me once. The o-ring had moved out of where it was supposed to seat and jammed the bezel. The only thing that worked for me was to remove it, replace the o-ring and reinstall the bezel. I used a little bit of silicone grease on the o-ring to keep it from moving the second go-round.

The bezel gasket in mine is fine. Nor did it come off when putting it in. I'm starting to suspect the dagaz crystal was not made for the oem inserts, altough it says so on the site. The chamfer in the oem crystal is way more pronounced.
Thank you for taking the time to reply here!

SKX007 bezel not turning.

ZIELSZIEK

duc

ZIELSZIEK

Similar threads

Sharing new acquisition. Bezel not turning

SKX007 Bezel gasket size and where to buy?