Omega Seamaster 166.010: Buying Advice

Posts
1
Likes
0
Hi all,
I have been in the market for a 166.010 with a BOR bracelet and preferably a crosshair dial. I was hoping to get opinions on the condition of this listing and if $1450 USD would be an overpay. I have looked at the fishing guide but would appreciate second opinions. I have been struggling to find alternatives on eBay and chrono with a BOR bracelet in good condition around this price point. Seller has listed the watch as serviced.

One thing I wanted to flag is the apparent sliding clasp on the BOR bracelet and if it was possibly a replacement bracelet. This thread appears to indicate these sliding clasps were present on early issues of the BOR bracelet.


Any thoughts would be much appreciated!
 
Posts
97
Likes
156
I know next to nothing about BOR bracelets, but the watch itself looks like a good, honest example of the reference to my eyes.
 
Posts
346
Likes
1,009
Avoid, IMO it's a redial, though I am by no means an expert. The crosshair should not be interrupted and the minute hashes are a tad too long.
 
Posts
3,249
Likes
6,806
The crosshair should not be interrupted
Both variants are seen in the pictures-universe of www....I judge: 馃憤
 
Posts
1,104
Likes
3,801
I would think the sliding clasp would be OK for this era and the watch looks fine to me. Is the listing from Japan? The cyclops crystal is supposedly a replacement but 166.010s with cyclops are very common here. I don't see a stamp on the endlinks so these may be aftermarket replicas. This would not stop me from buying the watch. The original thin crown is nice to have but it's likely to have little moisture resistance. Cheaper examples on Japanese Yahoo! Auctions can be had but they're likely to have a host of issues.
 
Posts
346
Likes
1,009
Both variants are seen in the pictures-universe of www....I judge: 馃憤
You're right. Broken crosshairs started coming up after the mid sixties, and late 166.010 fall into that period. My apologies to the OP.