Hi everybody!
Yesterday I found the upper pusher of my Speedy a bit to distant to the watch.
I had a look and suddenly held it in my hand!
Can someone tell me if this is just a screwing problem or a job for a watchmaker.
Can the pusher be reused?
Thanks a lot for your help!
Yann

 

Its a job for a watch maker. The case needs to be opened and the movement removed in order to have access to the screw pin for the pusher.

If the thread on the screw is still in good condition then it should be reusable, however it probably indicates that its been a long time since the watch was serviced so it might be worthwhile to think about a full service in the near future.

 

Thank you pascs,
ok, I see.
Regarding the service, that was my thinking too.
I own that watch since some months now and a full service could be good.

 

Agree with the above advice.

Make sure that you don't loose the spring, you can just make it out surrounding the threaded part of the screw.

I always use a small drop of loctite on the threads to prevent loosening.

I would also make sure that the o'rings on this pusher and the other are replaced and properly lubricated.

Nice watch by the way, my favorite for sure...