Am I just royally unlucky with Omega?

Posts
17
Likes
5
Just wanted to vent a little about my terrible luck with Omega lately.


I have a few Omegas in my collection, but the 321 and Snoopy are easily my two most prized pieces. Both were purchased brand new from an Omega boutique in Singapore, and both are only around a year old. Somehow, both have already ended up needing a trip to the service centre.


First, the 321.


Earlier this year, I had a bit of a scare with some strange timegrapher readings, which I posted about here:



Then around April, the watch started losing about a minute a day, so I had to send it in for service.


Got it back after four months, actually sooner than what the boutique sale associate had told me, which was a nice surprise.


Unfortunately, the positional variation after servicing is still quite large, ranging from around -16s/day (crown down) to +13s/day (crown up), overally +7 on wrist. Not exactly what I was hoping for, but somewhat acceptable I suppose, so I decided to live with it.


And now, the Snoopy...


Was winding it today as usual, and after about 20 turns, I suddenly felt a jolt through the crown.

After that, I could just keep winding indefinitely. No more stopping point, and there's a slipping noise whenever I wind it near where the stopping point used to be. The strange thing is that the watch was still running.


I suspect something has gone wrong with the mainspring or winding mechanism, but won't know for sure until Omega examines it. So another trip to the service centre it is.


Two of my favourite watches, both barely a year old, and both developing mechanical issues. I understand that these things can happen with mechanical watches, but having it happen to both watches within such a short time is really frustrating.


I still love Omega, and especially these two watches, which makes the whole experience even more disappointing.


Am I just royally unlucky, or is this more common than I thought?


Anyone experienced something similar with the 3861, where the winding stop suddenly disappears but the watch continues running?


Now just keeping my fingers crossed that nothing happens to my Speedmaster '57 and Seamaster next. 😅
 
Posts
30,330
Likes
78,269
Unfortunately, the positional variation after servicing is still quite large, ranging from around -16s/day (crown down) to +13s/day (crown up), overally +7 on wrist. Not exactly what I was hoping for, but somewhat acceptable I suppose, so I decided to live with it.
That Delta is outside of Omega specs, although the average rate is within specs...

Anyone experienced something similar with the 3861, where the winding stop suddenly disappears but the watch continues running?
Broken mainspring. The spring has broken out at the tang end, so most of the spring is intact, still giving the watch some power to run. This typically leads to lower power reserve though.

Broken mainsprings are not all that unusual - I have an 1861 in the shop right now that had the exact same thing happen...tang end broken off:

 
Posts
2,006
Likes
3,903
To have that happen to you with 2 new watches is very unlucky i think, and although double or triple checked in QC before sending it off to the shop it still happens as Archer explained. Bummer.
When you think of cars in particular the majority gets a recall with all the electronics and airbags etc these days so it happens a lot.

I think the discussion should be ( demand it ) about a much faster return time for a client who bought new imo, to restore that special VIP/AD experience the pricetag is also based upon, and these watches should be fixed in weeks and not months.
Or maybe next time buy used 😀 so these issues are fixed already ?