I sent my Seamaster in for service in January 2021 to a service center. Last week I had surgery so I didn't wear my watch for about for about 48 hours. I wound it the morning I put it back on but now when I take it off at 5:00pm the next morning it stops at about 3:00 am. The watch has done this for the past three days. Any thoughts other than sending it back to Omega.

 

Are you fully winding it?

 

I thought so, When I put the watch back on after not wearing it I wound it about 25 times.

 

Try 40+ times. FULL turns of the crown.

 

+1 on this. I suspect the OP is winding 25 partial turns, so probably closer to 12 full than 25 full. That's not nearly enough to wind it fully.

 

Thanks guy's you were right. I should have wound it more, I'm going to blame the anesthesia.