Hello everyone,

I got a very nice 1171-bracelet with embossed Omega-logo but the "normal" 633 endlinks doesn't fit here. You can find several indentical braclets but nowhere is shown the bracket with endlinks.

Interesting: The 640 (normally used with 1175 bracelets) endlinks are matching because the have the correct width of 10.6mm but it doesn't look harmonic ;-)
The clasp looks like a 1175-clasp but is a little bit shorter. The single links are not flat but vaulted (?) like seen on later 1171.

Does anyone have the same novolink-braclet? Which are the correct endlinks?

Best, Ralph

 

677 endlinks will fit

 

1171 Novolink were fitted on Seamaster Cosmic 2000 166.0128 (676 endlink), 166.0129 (676 endlink) and 166.0130 (677 endlink).
As any other 1171, it should fit 633 endlinks.

Yours is simply not a Novolink (widest link is obviously not 20mm), but some parts put together...

 

@uwsearch : Thanks, that's possible for sure but if, which other bracelet are the links from?

This braclelet from urdelar is gilt but otherwise the same as mine.
I hope, it's ok, if I'm posting this link, if not, Admins please delete it.
http://www.urdelar.se/Bracelet, Omega, no: 1171, Gilted, NOS

 

I've a No.12 "1175" with similar rouded links and same size. I thought that it was put together too, but no idea about it's origin.

 

I have a question, if I may: I am looking for end links for my Seamaster Cosmic 166.0130 and you mention that 677 should be used. Will 676 fit as well? It seems very difficult to find 677 end link anywhere, while 676 can be had.

 

676 won't fit... And 677 are common, and probably still available from omega

 

Thank you!

 

I'm revisiting this old post because I know find myself holding a bracelet that is IDENTICAL to the one the OP showed. It is also an 1171 Novolink bracelet but the ends that measure 10.6mm (not 9.1 like a "typical" 1171).

I'd like to use it on my Speedmaster Pre-Moon but it is not compatible with the 633 endlinks.

In this thread, someone said that 677 links will fit but I don't see how. End links with a gap of more than 10.6mm are required (677 end links only have a hole width of 9.8. Any suggestions on which endlinks I actually need?

 

That's not a 1171 then.... Clasp was changed.

 

That was m initial assumption as well. I'm just second guessing it since my bracelet exactly matches the one that the OP has. Everything, I mean everything is the same. The shape of the embossed logo on the clasp, the text inside the clasp, the measurements of the last link...