DIY Crown

Posts
8
Likes
33
Caution: I do not want to say you should work with your precious watches, specially if you do not know what to do or you do not feel confident to do so. In these cases leave it for professionals. But if you do have some amount of mechanical background and you are pretty confident that you are not doing anything that can't be undone...this might be fun way to get to know your watch.

Short background:
I bought this ref 212209 few month ago, and it was not perfect but I liked it a lot. The only thing that always stick to my eye was the aftermarket crown which was too small in diameter, too high and it just was not as it supposed to be on 1940s dress watch. So I did search for replacement. I even bought another Universal Geneve just for the crown, but that is another story. Anyway, finding the correct crown was not as easy as I thought.

So what do you do when you don't find crown you are looking for, you made it yourself:
Although I was able to get most of the dimensions from this original crown and stem on the watch, but I didn't have correct dimensions of the crown itself (diameter and height). So I first tried to estimate what the dimensions could/should be. But while I was looking for the crown I found another UG watch with correct looking crown. And from that I got rest of the missing dimensions. But even then I couldn't really found exact match what I was looking for. But there was one seller on eBay who had pretty decent looking crowns on sale and the price was quite low, so I though why not. It can't be worse than the one on the watch. Maybe I can work these out a bit to fit on my need.
It took some weeks to get the crowns but I finally got these on this week and had some time to work on these today, so here is what I did::

1. So the starting point was 'Watch CROWN 5.2mm Stainless Steel, Swiss Made, TAP 10' (seller in eBay was timelessclassicwatches in US). And all the dimensions were correct for this Universal Geneve watch.
2. The crowns inside edge was flat, not in angle like often in Swiss made crowns. So I attached crown on the hand drill and took my wife's nail file and I filed the crowns inside edge on angle. (Could have filed bit more, but it's ok.)
3. I already had new stem, my wife's file and normal lock tight. So I did cut the stem close to right size, filed the cutting end so that it went on crown thread, tested, filed bit more and tested again until it was exactly same length as original one. Little bit of lock tight and set everything together. From photos you can see the result. May not be perfect, but I pretty happy for the result.